Home > Forums > Software User Forums > Siemens

Meshing

Mark Forums Read

Reply

Search this Thread

June 9, 2009, 07:58	Meshing	#1
wei New Member wei Join Date: Apr 2009 Posts: 17 Rep Power: 16	STAR-CD mentions body-fitted meshing capabilites. I was give a few vertices as a starting point to mesh an engine. What can I do from this starting point? I have been investigating this problem since a week ago. If somebody could give me some hints, it will be a big help. Regards, Wei

June 11, 2009, 05:54		#2
wei New Member wei Join Date: Apr 2009 Posts: 17 Rep Power: 16	any particular star-cd commands I can use?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 11:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 05:01
doubt on meshing	joe	FLUENT	2	September 12, 2005 13:17
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08

All times are GMT -4. The time now is 11:10.