Informations needed about Moving Wall
 

Hi all,

Has anyone information about the moving wall (real displacement) in Star CCm+ because there aren't much information in the Starcc+ Help.

My problem is shonw in the attached picture.

Thanks a lot for all your answer.

Adrien

Read the other topics about this.
Run 5 steps, change mesh, remesh and 5 steps again etc... ;)

The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ...

you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box.
I suggest you post to the STAR-CCM+ forum in future.