Extrusion

sreenivas · June 28, 2012, 04:58

Hi

Any body knows how to Extrude the Mesh after generating the volume mesh in STAR-CCM+???

Regards
srinivas

flotus1 · July 3, 2012, 04:11

It has been quite a while since I last used CCM+, but I think it works like this:

Activate the extrusion method in the meshing section.
Then I think you find the option for the extrusion somewhere in the boundary conditions section.

abdul099 · July 6, 2012, 18:06

Right, but you need to volume mesh again after setting the extrusion parameters. You can't extrude after volume meshing, except with directed meshing (which is brand new with version 7.04).

June 28, 2012, 04:58	Extrusion	#1
sreenivas New Member sreenivas Join Date: Jul 2010 Posts: 23 Rep Power: 15	Hi Any body knows how to Extrude the Mesh after generating the volume mesh in STAR-CCM+??? Regards srinivas

July 6, 2012, 18:06		#3
abdul099 Senior Member Join Date: Oct 2009 Location: Germany Posts: 636 Rep Power: 21	Right, but you need to volume mesh again after setting the extrusion parameters. You can't extrude after volume meshing, except with directed meshing (which is brand new with version 7.04). __________________ We do three types of jobs here: GOOD, FAST AND CHEAP You may choose any two!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Divergence / Convergence for different inlet extrusion lengths	Janshi	STAR-CCM+	8	October 27, 2011 10:32
Difficult ICEMCFD question: Extrusion	Walter	CFX	11	April 19, 2011 02:22
Proam creates negative extrusion cells if away from origin	cfdengineer	STAR-CD	1	January 27, 2011 05:02
Creating Extrusion layer in ProAm w/ small geomtry	Alicia	Siemens	2	September 1, 2005 12:32
Extrusion Modeling	Elliot Schwartz	Main CFD Forum	1	September 11, 1998 19:08

July 3, 2012, 04:11		#2
flotus1 Super Moderator Alex Join Date: Jun 2012 Location: Germany Posts: 3,399 Rep Power: 46	It has been quite a while since I last used CCM+, but I think it works like this: Activate the extrusion method in the meshing section. Then I think you find the option for the extrusion somewhere in the boundary conditions section.