 |
 |
 |
|
|
|
[Sponsors] | ||||
July 17, 2012, 09:47
|
Boundary layer first cell distance
|
#1 |
|
New Member
abishai murday
Join Date: Dec 2010
Posts: 23
Rep Power: 15  |
Hi
I would like to start my first prism cells for my boundary layer at a distance of say 0.00001 away from the wall, im a bit confused about the type of stretching mode i have to use to get that required distance...could someone help me out please... Regards |
|
|
|
|
|
July 19, 2012, 10:23
|
|
#2 |
|
Member
Ryan Coe
Join Date: Jun 2010
Location: Albuquerque, NM
Posts: 98
Rep Power: 15 |
If you go to Continua-Mesh-Models-Prism Layer Mesher, you can select the Stretching Mode: choose Wall Thickness.
Then, under Continua-Mesh-Referece Values-Thickness of Near Wall Prism Layer, you can set your desired thickness. Hope this helps, Ryan
__________________
Ryan |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh refinement regions ignored | guitarbren | OpenFOAM Meshing & Mesh Conversion | 2 | April 9, 2013 03:59 |
| Boundary Layer roughness/ low reynolds wall treatment | Luigi_ | STAR-CCM+ | 1 | March 14, 2012 08:40 |
| [snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
| Boundary Layer - dimensionless wall distance y+ | MartinRei | Main CFD Forum | 4 | November 3, 2011 01:14 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Linear Mode
