Mass fraction against time (urgent!!!!!)

itsme_kit · August 9, 2012, 11:20

Hi
I'm using multi-component model to model air and co in a pipe
There is no reaction
How can I get a plot about mass fraction against time in a interest point?
Currently I only know how to view mass fraction in a scalar plot
Many thanks for your help

eRzBeNgEl · August 16, 2012, 15:36

Create a point as a derived part, then create a x,y,z table..us as part your point and set the scalars to parameters you are interested, this should work

Then you can visiualize the table by creating a table plot.

Zeppo · September 9, 2012, 11:53

Create a point as a derived part.
Create a report to get an interested parameter (scalar function) at your point.
Create a monitor and plot from your report.
Export your plot values to .csv file to use them in any external software.

August 9, 2012, 11:20	Mass fraction against time (urgent!!!!!)	#1
itsme_kit Senior Member Join Date: Jan 2012 Posts: 197 Rep Power: 14	Hi I'm using multi-component model to model air and co in a pipe There is no reaction How can I get a plot about mass fraction against time in a interest point? Currently I only know how to view mass fraction in a scalar plot Many thanks for your help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Running dieselFoam error	adorean	OpenFOAM Running, Solving & CFD	119	February 1, 2016 14:41
multicomponent flow-component mass fraction at inlet	mengyue1	CFX	0	January 4, 2012 23:49
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03
separate time step for mass fraction?	joe	CFX	1	August 12, 2007 18:30

August 16, 2012, 15:36		#2
eRzBeNgEl Senior Member Join Date: Dec 2010 Posts: 135 Rep Power: 15	Create a point as a derived part, then create a x,y,z table..us as part your point and set the scalars to parameters you are interested, this should work Then you can visiualize the table by creating a table plot.

September 9, 2012, 11:53		#3
Zeppo Senior Member Sergei Join Date: Dec 2009 Posts: 261 Rep Power: 21	Create a point as a derived part. Create a report to get an interested parameter (scalar function) at your point. Create a monitor and plot from your report. Export your plot values to .csv file to use them in any external software.