CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   STAR-CCM+ (https://www.cfd-online.com/Forums/star-ccm/)
-   -   Biased meshing in Star CCM+ (Help needed) (https://www.cfd-online.com/Forums/star-ccm/110311-biased-meshing-star-ccm-help-needed.html)

firaga December 7, 2012 14:40

Biased meshing in Star CCM+ (Help needed)
 
Hello guys, I am a frequent ANSYS-FLUENT user but I have a project I need to do in Star CCM+

http://i318.photobucket.com/albums/m...rflatplate.png

I am doing a flow over a flat plate simulation

as you can see, I need a finer mesh along the bottom side, which will be the flat plate for accuracy and efficiency.

This is really easy in Ansys FLUENT, all I have to do is just enable mesh bias.

but there is no bias option in Star CCM+

Is there a way to create this mesh in Star CCM+?

Thank you.

lava12005 December 7, 2012 23:52

You can try to use prism layer mesher since it is used for the boundary layer mesh.
You can control the expansion from the wall with this.

dke December 10, 2012 11:29

In this case i recommend the extruder. available in model selection of mesh continuum.
Extrusion type option is located below the Mesh Conditions node of your Boundaries.
Extrusion Parameters option will appear below Mesh Values node.

Once chosen, your are able to define the extrusion length, the amount of layers and the stretching ratio from one layer to the next layer.

jjanakpatell December 14, 2012 09:46

mESH pROBLEM IN STAR CCM +
 
1 Attachment(s)
hi users,
I have a problem in star ccm+,
when I was start a volume mesh, then i got a message memory access exception.
like,
Attachment 17646

What should i do for slove this problem?
Thanks and Regards,
JOSEPH:confused:

abdul099 December 14, 2012 21:18

Although I know it must be pretty hard, would you mind to give a little more information?

Quote:

Originally Posted by jjanakpatell (Post 397553)
hi users,
I have a problem in star ccm+,
when I was start a volume mesh, then i got a message memory access exception.
like,
Attachment 17646

What should i do for slove this problem?
Thanks and Regards,
JOSEPH:confused:


jjanakpatell December 17, 2012 07:33

need a suggestion
 
Hello abdul,
thanks for reply.but, thanks god i solved the error of volume mesh problem.
i have some further problem,
my project is related to exhaust gas.
in my project i have to simulate the to a exhaust gas + soot simulation.
so which cfd model suitable related to my project.

DATA:
pIPE INNER DIA - 54MM
OUTER DIA: - 60MM
TEMPRETURE OF EXHAUST GAS : -250 C
EXHAUST FLOW VWLOCITY IS 20 M\S
SO; shall i use a Eulerian multiphase cfd model?


i need ur suggestion.

thanks and regards,
joseph:confused:


All times are GMT -4. The time now is 02:12.