Zero radial coordinates found on non-axis face in boundary OUTLET

Vassilis · February 20, 2013, 13:01

Hi!
I am dealing with an axisymetric turbulent jet. The problem is that when i try to initialize solution i get this message: Zero radial coordinates found on non-axis face in boundary OUTLET. I can't understand whats the problem, so if anyone can help me find a solution it would be great!
Thnx!

mmntmflx · February 27, 2013, 06:27

Hi Vassilis,

If you want to set up an axisymmetric model,

1. Converting plane(for convert 3D to 2D operation) have to be XY plane, that is, 3D mesh compress through the Z axis.

2. You have to choose correct axis for given geometry, i think your problem is here (setup boundary type).

February 20, 2013, 13:01	Zero radial coordinates found on non-axis face in boundary OUTLET	#1
Vassilis New Member Join Date: Feb 2013 Posts: 1 Rep Power: 0	Hi! I am dealing with an axisymetric turbulent jet. The problem is that when i try to initialize solution i get this message: Zero radial coordinates found on non-axis face in boundary OUTLET. I can't understand whats the problem, so if anyone can help me find a solution it would be great! Thnx!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 18:22
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
8x icoFoam speed up with Cufflink CUDA solver library	kmooney	OpenFOAM Running, Solving & CFD	42	November 6, 2012 12:37
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 09:48

February 27, 2013, 06:27		#2
mmntmflx Member Melih Meriç Join Date: Apr 2011 Posts: 46 Rep Power: 16	Hi Vassilis, If you want to set up an axisymmetric model, 1. Converting plane(for convert 3D to 2D operation) have to be XY plane, that is, 3D mesh compress through the Z axis. 2. You have to choose correct axis for given geometry, i think your problem is here (setup boundary type).