|
[Sponsors] |
April 22, 2013, 03:55 |
Trouble with water-air interface
|
#1 |
New Member
Join Date: Mar 2013
Posts: 3
Rep Power: 13 |
Hello,
I am simulating a free fall lifeboat according to the tutorial, but for some reason my volume fraction of water scene displays the air-water interface very distorted. The first time I ran the solution everything was fine, but after some mesh improvements it became this way (see picture). I have also tried with the original mesh settings again, and clearing the solution. Any suggestions on what to try? |
|
April 22, 2013, 09:10 |
|
#2 |
New Member
Join Date: Mar 2013
Posts: 3
Rep Power: 13 |
I solved it.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 08:04 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |