 |
 |
 |
|
|
|
[Sponsors] | ||||
May 18, 2013, 12:22
|
Prism Layer on DTMB 5415 test case
|
#1 |
|
New Member
FRANCE
Join Date: May 2013
Posts: 1
Rep Power: 0  |
Hi everybody,
I'm trying to use star CCM as a virtual towing tank and I would like to test the process on the DTMB case. Anyway I'm not very satisfied about the prism layer, which have some difficulties when concavity and convexity occurs. I'm still a beginer in star Ccm but guess it is possible to mesh it better. Do you have any ideas to improve it? Thanks. |
|
|
|
|
 |
| Tags |
| dtmb 5415, prism layer, towing tank |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case | sharonyue | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 23:34 |
| ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 14:56 |
| Trimmer & prism layer | peresah | STAR-CCM+ | 6 | October 6, 2009 14:39 |
| [Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 15:02 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
Linear Mode
