[HELP] Can't get results as per report.

wkwong · February 24, 2014, 08:01

Hi,

My project:
Cooling of rotating tube, rotating at 6000 rpm around an axis outside of itself and convection is allowed everywhere except the base of the tube (cone shape horizontally). Its inital condition is 369k and surrounding is 300k. The dotted line is the axis of rotation. I need to get similar results as in my professor, however, I could not find out where is wrong even after trying a few months. Thus unable to get the results.

Any help PLEASE?? Appreciate if anyone could help me with this project.

my email is masterlancer@hotmail.com

me3840 · March 4, 2014, 13:13

If you want help you're going to need to give far more information than this.

February 24, 2014, 08:01	[HELP] Can't get results as per report.	#1
wkwong New Member wen kang Join Date: Feb 2014 Posts: 9 Rep Power: 12	Hi, My project: Cooling of rotating tube, rotating at 6000 rpm around an axis outside of itself and convection is allowed everywhere except the base of the tube (cone shape horizontally). Its inital condition is 369k and surrounding is 300k. The dotted line is the axis of rotation. I need to get similar results as in my professor, however, I could not find out where is wrong even after trying a few months. Thus unable to get the results. Any help PLEASE?? Appreciate if anyone could help me with this project. my email is masterlancer@hotmail.com

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM - Validation of Results	Ahmed	OpenFOAM Running, Solving & CFD	10	May 13, 2018 18:28
Oscillating Airfoil Poor Results at High k (reduced frequency)	dancfd	OpenFOAM Running, Solving & CFD	3	November 4, 2013 08:32
Transient Run - Output "Time" in partial results?	evcelica	CFX	2	May 16, 2012 21:36
wind tunnel results vs fluent	pixie	Main CFD Forum	1	August 20, 2009 08:02
CFX cylinder or sphere benchmark results	Mel	CFX	1	August 8, 2005 18:47

March 4, 2014, 13:13		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	If you want help you're going to need to give far more information than this.