tutorial

yorelchr · March 12, 2014, 04:12

hello everyone

I'm trying to practise meshing with starccm.
Is there any problem with the first tutorial (manifoldWrap) : no way to pick up the 4 corner to create a surface (step before run leak detection) or is there something one should be careful when selecting these 4 points? I can only select 2 of them. Tride again and again, but no way...a bug?

Thank you for any clue.

me3840 · March 12, 2014, 11:03

You are using the polygonal patch tool in this step, it is not necessary to explicitly select vertices. As long as you click somewhere on the flat face you should be OK.

March 12, 2014, 04:12	tutorial	#1
yorelchr Senior Member christine Join Date: Jul 2009 Location: europe Posts: 125 Rep Power: 16	hello everyone I'm trying to practise meshing with starccm. Is there any problem with the first tutorial (manifoldWrap) : no way to pick up the 4 corner to create a surface (step before run leak detection) or is there something one should be careful when selecting these 4 points? I can only select 2 of them. Tride again and again, but no way...a bug? Thank you for any clue.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem on Fluent Tutorial: Horizontal Film Boilig	Feng	FLUENT	2	April 13, 2013 05:34
[Virtualization] OpenFOAM oriented tutorial on using VMware Player - support thread	wyldckat	OpenFOAM Installation	2	July 11, 2012 16:01
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
Rotor/stator tutorial, and how to...	gilberto	CFX	5	January 21, 2002 09:41

March 12, 2014, 11:03		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	You are using the polygonal patch tool in this step, it is not necessary to explicitly select vertices. As long as you click somewhere on the flat face you should be OK.