Restarting the simulation

KTJ · April 29, 2014, 14:46

Hello,
I ran a simulation for a case of an aerofoil with 2000 steps as stopping criteria. Now, I have done some mesh refinement around the aerofoil and want to re-run the simulation with same stopping criteria [2000 steps]. But STAR CCM+ won't let me do it. It runs 1 iteration and says 'Stopping criterion maximum steps satisfied'. How do I re-run the simulation again from step 1 as it it were fresh??

plucas · April 29, 2014, 21:56

At the top, click solution and then clear solution. The re-run

KTJ · April 30, 2014, 00:21

Quote:

Originally Posted by plucas

At the top, click solution and then clear solution. The re-run

Thanks Plucas! I was stuck at this for a long time. I tried searching it in the object tree, but couldn't. Thanks again!

plucas · April 30, 2014, 14:39

Quote:

Originally Posted by KTJ

Thanks Plucas! I was stuck at this for a long time. I tried searching it in the object tree, but couldn't. Thanks again!

No problem! I had the same problem a few years back

April 29, 2014, 14:46	Restarting the simulation	#1
KTJ New Member Kshitij Join Date: Apr 2014 Location: Cookeville, TN Posts: 4 Rep Power: 11	Hello, I ran a simulation for a case of an aerofoil with 2000 steps as stopping criteria. Now, I have done some mesh refinement around the aerofoil and want to re-run the simulation with same stopping criteria [2000 steps]. But STAR CCM+ won't let me do it. It runs 1 iteration and says 'Stopping criterion maximum steps satisfied'. How do I re-run the simulation again from step 1 as it it were fresh??

April 29, 2014, 21:56		#2
plucas Senior Member Anonymous Join Date: Dec 2011 Location: USA Posts: 108 Rep Power: 13	At the top, click solution and then clear solution. The re-run HWilliams79 likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
a simulation with rotation and vibration	liuzexiang	CFX	34	September 16, 2013 08:12
Convergence of jet flow simulation	MiraLisa	FLUENT	0	August 15, 2013 04:44
Requiring some help regarding tornado simulation	amarjogot	Main CFD Forum	0	June 20, 2013 12:26
GUI crash and simulation engine still running	RPJones	FLOW-3D	2	November 9, 2010 08:18
Problem restarting a simulation from an intermediate point.	sergiorbrett	CFX	2	April 21, 2010 17:11