CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > Siemens > STAR-CCM+

Offset strip Fin_validation

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   September 17, 2014, 04:09
Default Offset strip Fin_validation
  #1
New Member
 
Tae Kyeong Lee
Join Date: Sep 2014
Posts: 3
Rep Power: 11
stayinside is on a distinguished road
Hi, I'm Tae Kyeong Lee from Republic of Korea.

I have a problem w/ validation for offset strip fin.

Actually, I read the paper written by Manglik(1995) and Kwan Soo Lee(2010), but I can't get a same tendency.

In Reynolds number = 500~600, it seems quite in accordance with papers.

But, Lower than Re=500, j factor looks higher than it in paper.

and Higher than Re=600, j factor is lower than it in paper.


boundary condition is like ,

velocity inlet, pressure outlet, periodic condition at both sides,

top and bottom is wall, constant temperature.

I used the same hydraulic diameter w/ papers and Nusselt number is also

considered by hydraulic diameter.

I use the mean velocity at fin inet and fin outlet to get a reynolds number.

F factors are almost in accordance w/ papers.

What should I consider about it?

Thx to read it. And If you get a solution or advice, I'll be grateful.
stayinside is offline   Reply With Quote

Old   September 17, 2014, 04:14
Default Addition information
  #2
New Member
 
Tae Kyeong Lee
Join Date: Sep 2014
Posts: 3
Rep Power: 11
stayinside is on a distinguished road
wall constant temperature is 380K. and Inlet temperature is 300K.

In Re=500, outlet air temperature is 379.1261K and Re=400, 379.0879K

Re=300, 379.7462K

fin's alpah = 05, sigma=0.033, gamma = 0.0833 Dh=0.001557(m)

should I set the air wall (at fin top and bottom) in adiabatic?
stayinside is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 15 November 18, 2020 07:09
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch gschaider OpenFOAM Installation 225 August 25, 2015 20:43
DirectMappedPatchBase, offset and samplePatch Fransje OpenFOAM Bugs 4 May 1, 2013 04:38
chtMultiRegionFoam - offset santoo_cfd OpenFOAM 11 November 1, 2010 16:01
[Other] Offset warning Mercato OpenFOAM Meshing & Mesh Conversion 5 December 2, 2009 07:35


All times are GMT -4. The time now is 22:34.