Mesh problem in Starccm+ 9

jsb12136 · October 3, 2014, 09:34

I am new to this software, and I am trying to simulate the rotating motion of a vertical axis water turbine. After I set up the boundaries and regions, an error said"trimmer can not accommodate multiple regions in one continuum" shows up. What is the mistake of this?

mi_cfd · October 4, 2014, 18:12

Hi Xiaosong,

The Trimmer mesher in STAR-CCM+ can only mesh one region at a time and it does not create conformal mesh at the interface.

So, if you are using the Trimmer to mesh multiple regions, you have to enable "Per-region meshing" or "Per-part meshing" under:

- Continua > Mesh 1 > Models > Trimmer : Properties
(if you are using "region-based meshing")

or

- Geometry > Operations > Automatic Mesh 1 > Models > Trimmer : Properties
(if you are using "parts-based meshing")

There are some relevant tutorials in STAR-CCM+ documentation including several ones on meshing and one on a rotating fan, that you might find useful.

Regards,
MI

October 3, 2014, 09:34	Mesh problem in Starccm+ 9	#1
jsb12136 New Member Xiaosong Zhang Join Date: Oct 2014 Posts: 14 Rep Power: 13	I am new to this software, and I am trying to simulate the rotating motion of a vertical axis water turbine. After I set up the boundaries and regions, an error said"trimmer can not accommodate multiple regions in one continuum" shows up. What is the mistake of this?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 05:27
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
Overset MESH problem DFBI 6DOF	Ale85	STAR-CCM+	0	October 1, 2013 13:25
[ICEM] ICEM Structured Mesh Problem	OMJT	ANSYS Meshing & Geometry	3	March 22, 2013 11:06
[GAMBIT] SOFC crossflow mesh possible problem???	epc1	ANSYS Meshing & Geometry	1	February 4, 2013 02:57

October 4, 2014, 18:12		#2
mi_cfd New Member Join Date: Apr 2009 Posts: 5 Rep Power: 18	Hi Xiaosong, The Trimmer mesher in STAR-CCM+ can only mesh one region at a time and it does not create conformal mesh at the interface. So, if you are using the Trimmer to mesh multiple regions, you have to enable "Per-region meshing" or "Per-part meshing" under: - Continua > Mesh 1 > Models > Trimmer : Properties (if you are using "region-based meshing") or - Geometry > Operations > Automatic Mesh 1 > Models > Trimmer : Properties (if you are using "parts-based meshing") There are some relevant tutorials in STAR-CCM+ documentation including several ones on meshing and one on a rotating fan, that you might find useful. Regards, MI