|February 2, 2015, 23:00||
Simulation of vehicle cornering
Join Date: Feb 2013
Posts: 13Rep Power: 6
I'd like to run a external flow simulation of a vehicle under cornering conditions.
I can set up geometry such as vehicle roll in CAD no problem but I believe I need a fluid domain in which the air moves radially, just as the track's relative motion would be observed by a driver looking down.
Does anyone know how this could be done in star-ccm+? Are there any relevant tutorials or similar to look at?
Best regards to all,
|February 9, 2015, 01:50||
Join Date: Nov 2010
Posts: 824Rep Power: 13
Are you doing this in steady state? If so you don't really need radial velocity, you just need to put the car in yaw.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Use homogeneous results as the initial guess for an inhomogeneous simulation||JuPa||CFX||5||December 26, 2014 14:44|
|[ANSYS Meshing] Streamlined vehicle boundary layer problem||Paul Fionn||ANSYS Meshing & Geometry||5||November 4, 2014 15:18|
|Convergence of jet flow simulation||MiraLisa||FLUENT||0||August 15, 2013 04:44|
|Simulation of a complex wing in solidworks flow simulation||niels1900||FloEFD, FloWorks & FloTHERM||6||April 20, 2011 10:44|
|STAR-CD in Vehicle Air Conditioner Simulation||Milan||CD-adapco||5||August 5, 2000 05:37|