 |
 |
 |
|
|
|
[Sponsors] | ||||
February 25, 2015, 20:05
|
Meshing: Invalid Integer Cast
|
#1 |
|
Member
Join Date: Nov 2012
Posts: 74
Rep Power: 15  |
Hi,
Every time I try to mesh a geometry with a high number of cells (usually above 90-100M) I get an "Invalid Integer Cast" error at the very end of the meshing (when it says "optimizing mesh"). I have tried to mesh on different processors, on a different number of processors, different simulations, different mesh sizes, without any luck... See the picture attached for what Starccm+ returns (I only did screenshot, could not copy paste here). Any idea? thanks for your help! |
|
|
|
|
|
March 4, 2015, 22:16
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 26 |
The problem looks like it is in the partitioner.
This is likely a bug, so I would give the case to your support engineer. However, have you tried: 1. meshing in serial 2. Clearing any existing grid before meshing this one |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| foamToTecplot360 | thomasduerr | OpenFOAM Post-Processing | 121 | June 11, 2021 11:05 |
| [swak4Foam] installation problem with version 0.2.3 | Claudio87 | OpenFOAM Community Contributions | 9 | May 8, 2013 11:20 |
| latest OpenFOAM-1.6.x from git failed to compile | phsieh2005 | OpenFOAM Bugs | 25 | February 9, 2010 05:37 |
| Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 07:59 |
| Can anybody help me to solve the list errors while compiling Openfoam 15 on Opensuse 103 32bit | coompressor | OpenFOAM Installation | 0 | November 12, 2008 20:53 |
Linear Mode
