|
[Sponsors] |
February 25, 2015, 19:05 |
Meshing: Invalid Integer Cast
|
#1 |
Member
Join Date: Nov 2012
Posts: 74
Rep Power: 13 |
Hi,
Every time I try to mesh a geometry with a high number of cells (usually above 90-100M) I get an "Invalid Integer Cast" error at the very end of the meshing (when it says "optimizing mesh"). I have tried to mesh on different processors, on a different number of processors, different simulations, different mesh sizes, without any luck... See the picture attached for what Starccm+ returns (I only did screenshot, could not copy paste here). Any idea? thanks for your help! |
|
March 4, 2015, 21:16 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
The problem looks like it is in the partitioner.
This is likely a bug, so I would give the case to your support engineer. However, have you tried: 1. meshing in serial 2. Clearing any existing grid before meshing this one |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
foamToTecplot360 | thomasduerr | OpenFOAM Post-Processing | 121 | June 11, 2021 10:05 |
[swak4Foam] installation problem with version 0.2.3 | Claudio87 | OpenFOAM Community Contributions | 9 | May 8, 2013 10:20 |
latest OpenFOAM-1.6.x from git failed to compile | phsieh2005 | OpenFOAM Bugs | 25 | February 9, 2010 04:37 |
Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 06:59 |
Can anybody help me to solve the list errors while compiling Openfoam 15 on Opensuse 103 32bit | coompressor | OpenFOAM Installation | 0 | November 12, 2008 19:53 |