|May 6, 2015, 10:53||
Erosion Star CCM+
Join Date: Nov 2014
Posts: 16Rep Power: 4
I am doing erosion modeling inside a pipe with sudden contraction and trying to compare it with the experimental results with different particle size. As in experiments increasing particle size increases the erosion rate.
But the problem I am facing is changing the particle size should increase the erosion rate but this not happening in my case...any suggestions??
I am using Neilson Model as specified in research paper with k-epsilon turbulent model.
Where I could be most possibly wrong carrying out the erosion simulation.
Your advice is most valuable...
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem when imported geometry from 3D CAD to star ccm,||TAREK GANAT||STAR-CCM+||1||May 21, 2013 22:15|
|Using starToFoam||clo||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||33||September 26, 2012 04:04|
|StarToFoam error||Kart||OpenFOAM Meshing & Mesh Conversion||1||February 4, 2010 05:38|
|error in star ccm||maurizio||CD-adapco||3||October 16, 2007 05:17|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|