|
[Sponsors] |
May 6, 2015, 10:53 |
Erosion Star CCM+
|
#1 |
New Member
Ayush Jain
Join Date: Nov 2014
Posts: 16
Rep Power: 11 |
I am doing erosion modeling inside a pipe with sudden contraction and trying to compare it with the experimental results with different particle size. As in experiments increasing particle size increases the erosion rate.
But the problem I am facing is changing the particle size should increase the erosion rate but this not happening in my case...any suggestions?? I am using Neilson Model as specified in research paper with k-epsilon turbulent model. Where I could be most possibly wrong carrying out the erosion simulation. Your advice is most valuable... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 22:15 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |