|
[Sponsors] |
May 22, 2015, 23:17 |
Circumferential Average of Data
|
#1 |
Senior Member
Join Date: Aug 2014
Posts: 160
Rep Power: 11 |
Hello,
I would like to do a circumferential average of my data located on a plane. Let me explain: for a given radius, I would like to do the circumferential average of the radial velocity for example. I used Tools Radial Internal Table but I'm not sure that it's the good way to do this because I don't think that an average is done with this method and moreover I don't know where the data are taken on my plane ... Can somebody help me ? Could I plot a line on the radius contour of my plane and do an average of data on this line and repeat this method for each line of radius contour ? Thank you very much |
|
May 23, 2015, 00:53 |
|
#2 |
Senior Member
Join Date: Aug 2014
Posts: 160
Rep Power: 11 |
I find, I did a isosurface number (200 isosurfaces = 200 radius) of the radial position on my interest plane but now I do not see how I can extract data for on isosurface one at a time ... ? I don't see how I can do the macro !
Does anyone knows how I can do a java macro to change the number of interest isosurface and calcul and report the average value obtained on a radius out to a file ? Quote:
|
|
May 27, 2015, 17:25 |
|
#3 |
Senior Member
Matt
Join Date: Aug 2014
Posts: 947
Rep Power: 17 |
I could be off base with this, but I would create a series of probes distributed at the radius you want.
If you are looking for surface averages and not point data you could maybe create a derived part > cylinder section although this will create a surface extending thorugh the whole input part. Its hard to visualize what you are wanting, perhaps a sketch would help if this is not what you were after? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
【Help】"Error: Update_Time_Level: invalid data" | Chen | FLUENT | 2 | August 24, 2014 07:51 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |
export data at nodes | Meenu | FLUENT | 1 | December 30, 2011 01:24 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
CGNS vs Tecplot Data Format | LWhitson2 | Main CFD Forum | 3 | July 1, 2011 13:50 |