CFD Simulation of a swimming pool using STAR CCM+

samoalfred · January 13, 2016, 09:06

Hello everyone.I want to simulate a swimming pool using STAR CCM+.Please how do I set it up. Any ideas please ? It is urgent. I want to set up a two dimensional model.

aroma · January 17, 2016, 09:07

What do you want to simulate in the pool? your question is too general.

samoalfred · January 17, 2016, 17:18

OK I want to simulate a counter current swimming pool .I want to use either a 2D and 3D models.I want to be sure about setting up the physics and boundary conditions. That is what I need help about. Please I can drop my mail if that will be better for communication. Thanks.

aroma · January 17, 2016, 17:43

I am not very experienced in free surface simulation. Try this one (http://www.cd-adapco.com/sites/defau...eric%20VoF.pdf).

You may need to use VOF.

Hope it helps.
Cheers,
Aroma

January 13, 2016, 09:06	CFD Simulation of a swimming pool using STAR CCM+	#1
samoalfred New Member Samuel Alfred Join Date: Jul 2015 Posts: 9 Rep Power: 10	Hello everyone.I want to simulate a swimming pool using STAR CCM+.Please how do I set it up. Any ideas please ? It is urgent. I want to set up a two dimensional model.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Shall I leave one core free when I run CFD simulation?	Pierre1	Main CFD Forum	1	March 12, 2015 04:46
Compressor Simulation in Star CCM+	chili023	STAR-CCM+	13	August 11, 2011 02:22
CFD-analysis of hydroplane: STAR CCM or Flow Simulation?	peterg07	Main CFD Forum	0	February 7, 2010 14:32
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
HELP!:CFD modelling using FLUENT in swimming pool	Tee	Main CFD Forum	0	September 7, 2005 20:48

January 17, 2016, 09:07		#2
aroma New Member Hamed Join Date: Jul 2012 Posts: 16 Rep Power: 13	What do you want to simulate in the pool? your question is too general.

January 17, 2016, 17:18		#3
samoalfred New Member Samuel Alfred Join Date: Jul 2015 Posts: 9 Rep Power: 10	OK I want to simulate a counter current swimming pool .I want to use either a 2D and 3D models.I want to be sure about setting up the physics and boundary conditions. That is what I need help about. Please I can drop my mail if that will be better for communication. Thanks.

January 17, 2016, 17:43		#4
aroma New Member Hamed Join Date: Jul 2012 Posts: 16 Rep Power: 13	I am not very experienced in free surface simulation. Try this one (http://www.cd-adapco.com/sites/defau...eric%20VoF.pdf). You may need to use VOF. Hope it helps. Cheers, Aroma