Macro Problem -- CFD Online Discussion Forums

April 20, 2016, 13:18	Macro Problem	#1
Gigaincfd New Member Join Date: Aug 2011 Posts: 2 Rep Power: 0	hi dear, I have a problem with one java macro for STARCCM+. I extract a fan moment on fan blades with report Moment. I create monitor and plot. I want to change this value when simulation run. I create a Macro but i have the problem in cycle 'for' because of i'm not able to read Iteration i-1 and the relative value of Fan Moment i-1. my logical cycle is if FAN moment (iteration i-1) is <-20 N-m change value of rpm of fan IT is possible to create? THX a LOT!!! Last edited by Gigaincfd; April 21, 2016 at 03:25.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DEFINE_HET_RXN_RATE macro problem	zzt_1234	Fluent UDF and Scheme Programming	0	December 6, 2010 03:16
Problem with FLUID_THREAD_P(t) macro	Sciaco	FLUENT	0	November 18, 2007 02:23
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

All times are GMT -4. The time now is 12:32.