Arrow in wind tunnel

JohnnyArrow · July 18, 2016, 17:32

Hello, I'm pretty new to STAR-CCM+, so this may be a silly question... But, I've tried search a few websites and can't seem to find any help.

I have modeled an arrow inside a wind tunnel. I have set up a report to measure the force coefficient going in the x direction so I can monitor the drag coefficient on a graph. However, I would like to start the simulation at 0 m/s and end the simulation at 45 m/s, but I am unsure how to go about doing this...
Any suggestions?

me3840 · July 18, 2016, 22:34

That's a pretty open ended question. I would suggest you start by going through some of the tutorials and coming back with more specific questions.

Edit: Or do you simply mean you want to ramp the boundary condition up? If so, you can make a CSV table of U vs iteration and specify that as the velocity for the boundary.

July 18, 2016, 17:32	Arrow in wind tunnel	#1
JohnnyArrow New Member John Rousey Join Date: Jul 2016 Posts: 1 Rep Power: 0	Hello, I'm pretty new to STAR-CCM+, so this may be a silly question... But, I've tried search a few websites and can't seem to find any help. I have modeled an arrow inside a wind tunnel. I have set up a report to measure the force coefficient going in the x direction so I can monitor the drag coefficient on a graph. However, I would like to start the simulation at 0 m/s and end the simulation at 45 m/s, but I am unsure how to go about doing this... Any suggestions?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[How to obtain supersonic flow inside a supersonic wind tunnel ?]	yx213	Siemens	1	September 17, 2014 13:52
flow in cyclic wind tunnel	yogesh@cfd	Main CFD Forum	0	November 8, 2010 04:28
how to consider perforated wind tunnel wall in CFD simulation	littlelz	CFX	4	June 11, 2009 05:51
Simulating a GÃ¶ttingen type wind tunnel in FLUENT	Chris	FLUENT	3	December 4, 2006 17:33
Virtual Wind Tunnel in FLUENT	ND	FLUENT	0	April 7, 2006 07:43

July 18, 2016, 22:34		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	That's a pretty open ended question. I would suggest you start by going through some of the tutorials and coming back with more specific questions. Edit: Or do you simply mean you want to ramp the boundary condition up? If so, you can make a CSV table of U vs iteration and specify that as the velocity for the boundary.