|
[Sponsors] |
May 18, 2018, 16:46 |
Creating separate mesh in one diagram
|
#1 |
New Member
Rashique Iftekhar Rousseau
Join Date: Feb 2018
Posts: 1
Rep Power: 0 |
Hi,
I am very new in Star CCM+ and right now I am trying to create separate meshes in one diagram (see attachment). 1. The outer region have structured mesh. 2. The gap region of three cylinders has unstructured mesh. 3. The neighboring region of each cylinder has homogeneous encrypted structured mesh of 10 layers. I have been trying but couldn't make it. Any help would be humbly appreciated. Thanks. 1.jpg 2.JPG 3.JPG |
|
May 30, 2018, 07:01 |
|
#2 | |
Senior Member
|
Quote:
Instead best solution is meshing in some other software like Hypermesh or so and then importing .msh or .case file to CCM. Importing .msh will directly forms region. Hope this helps. |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Creating Volume mesh from surface mesh | Vivek.oswal | Mesh Generation & Pre-Processing | 0 | August 7, 2015 14:11 |
[ICEM] Creating unstructured mesh and setting mesh sizes | cfdworks | ANSYS Meshing & Geometry | 0 | February 25, 2014 22:23 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |