 |
 |
 |
|
|
|
[Sponsors] | ||||
November 28, 2017, 17:13
|
Flow Simulation of Tesla Turbine
|
#1 |
|
New Member
Kausik
Join Date: Nov 2017
Posts: 2
Rep Power: 0  |
I am in dire straits right now. While simulating a Tesla Turbine (9 disks) what should be the equation of state. Should I consider constant density, real gas or ideal gas? The inlet velocity is 230m/s.
Someone please help me out. Regards Kausik |
|
|
|
|
|
November 28, 2017, 17:54
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
If you can't answer this question you probably shouldn't be starting a simulation yet. In the interest of saving your own time it's probably a good idea to review some fluid mechanics.
Think: at what point would an equation of state matter? What do you need to know about the fluid physics to consider something constant density (i.e. incompressible) or non-constant density (i.e. compressible)? |
|
|
|
|
|
|
November 28, 2017, 19:05
|
|
#3 |
|
New Member
Kausik
Join Date: Nov 2017
Posts: 2
Rep Power: 0 |
Ok. Since it is nearly going to reach sonic level its going to be compressible.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some questions about flow boiling simulation in Fluent | beastieboys6 | FLUENT | 8 | November 20, 2017 23:47 |
| [ANSYS Meshing] Aspect ratio of 3D simulation of flow over turbine with k-omega, SST | TKP | ANSYS Meshing & Geometry | 0 | October 8, 2015 11:26 |
| wind turbine blade flow simulation | rsskarthikeyan | FLUENT | 0 | May 27, 2015 05:40 |
| Simulation of flow in turbine | Jackpot | FLUENT | 1 | October 10, 2013 03:08 |
| Differences and functions of Solidworks Simulation and Solidworks Flow Simulation? | alpharays | Main CFD Forum | 0 | April 19, 2012 03:13 |
Linear Mode
