Vehicle Motion Through a Corner

Aditya_769 · August 6, 2018, 08:25

Hey guys,

I am a new member here and have been gone through many discussions on overset mesh. But I still cant seem to solve my problem.

I am currently trying to simulate a car through a corner by imposing Pitch and Roll on the body and yaw the velocity of flow through the inlet. I have a time based csv file for xyz velocity, Roll rate and pitch rate for the car. The place where I am struggling is to create a user defined field to interpolate the table and impose the motion to the body.

I have imported the 3 table into STAR CCM+ but cannot seem to interpolate the data from the table and impose the motion.

Could some one please help me with the same.

Thank you

Regards,
Aditya Mhatre

me3840 · August 8, 2018, 01:05

Did you read the user guide's section on interpolating tables? What seems to be the problem?

August 6, 2018, 08:25	Vehicle Motion Through a Corner	#1
Aditya_769 New Member Aditya Mhatre Join Date: Jul 2018 Posts: 1 Rep Power: 0	Hey guys, I am a new member here and have been gone through many discussions on overset mesh. But I still cant seem to solve my problem. I am currently trying to simulate a car through a corner by imposing Pitch and Roll on the body and yaw the velocity of flow through the inlet. I have a time based csv file for xyz velocity, Roll rate and pitch rate for the car. The place where I am struggling is to create a user defined field to interpolate the table and impose the motion to the body. I have imported the 3 table into STAR CCM+ but cannot seem to interpolate the data from the table and impose the motion. Could some one please help me with the same. Thank you Regards, Aditya Mhatre

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
How to use "translation" in solidBodyMotionFunction in OpenFOAM	rupesh_w	OpenFOAM Running, Solving & CFD	5	August 16, 2016 04:27
External management of solid motion (using dynamicmesh)	maxou1993	Main CFD Forum	0	July 28, 2015 11:37
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Impose an external mesh motion to coupling fluid slosh and vehicle movem	anmartin	OpenFOAM	0	February 1, 2012 17:30

August 8, 2018, 01:05		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	Did you read the user guide's section on interpolating tables? What seems to be the problem?