[tisa]

Hello together,

I'm currently simulating a steady state, mulitphase exhaust with a lagrangian spray. I use Bai-Gosman for the boundary conditions and set the "adhere mode" to evaporate. So every particle, which would create a film on the interface, will be evaporated.

I'd like to monitor the evaporated mass, which was caused "normally" by temperature of the interface and separately the mass which was created by the adhere mode.

Does anyone know if this is possible? The only thing i know is the "lagrangian mass source", but that's the combined evaporated mass.

Thanks in advance.
tisa