Line Probe as a Circle

Valentyn · October 22, 2018, 04:22

Hallo everyone,

I am trying to solve the following problem:

I have simulated the heat transfer between the battery cell and the cooling fluid. The battery cell is modeled as a cylinder (so, as a circle in 2D). Now I want to plot the temperature distribution along the entire 2D circumference. My questions are the following:

1. How can I create a line probe along the circle surface?

2. I want to have my resulting plot-axis as "Y -- temperature" and "X -- angle in degree °", so I can plot my temperature distribution in the 0° - 360° interval. Is it possible to define this kind of such "polar coordinate system" with it's origing in the centre of the battery cell circle?

Thank you all in advance!

Kind regards,
Valentyn

me3840 · October 22, 2018, 17:51

Create a cylindrical coordinate system at the center of the battery, then apply a plane section using that coordinate system. Don't use a line probe.

With the coordinate system and plane you can get the plot you want.

October 22, 2018, 04:22	Line Probe as a Circle	#1
Valentyn New Member Join Date: Oct 2018 Posts: 1 Rep Power: 0	Hallo everyone, I am trying to solve the following problem: I have simulated the heat transfer between the battery cell and the cooling fluid. The battery cell is modeled as a cylinder (so, as a circle in 2D). Now I want to plot the temperature distribution along the entire 2D circumference. My questions are the following: 1. How can I create a line probe along the circle surface? 2. I want to have my resulting plot-axis as "Y -- temperature" and "X -- angle in degree °", so I can plot my temperature distribution in the 0° - 360° interval. Is it possible to define this kind of such "polar coordinate system" with it's origing in the centre of the battery cell circle? Thank you all in advance! Kind regards, Valentyn

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem during mpi in server: expected Scalar, found on line 0 the word 'nan'	muth	OpenFOAM Running, Solving & CFD	3	August 27, 2018 04:18
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32
Problems of Duns Codes!	Martin J	Main CFD Forum	8	August 14, 2003 23:19

October 22, 2018, 17:51		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	Create a cylindrical coordinate system at the center of the battery, then apply a plane section using that coordinate system. Don't use a line probe. With the coordinate system and plane you can get the plot you want.