|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Ugur
Join Date: May 2018
Posts: 5
Rep Power: 6 ![]() |
Hello everyone,
I study on a project about flow around a ship in Star CCM+. While I was generating the mesh, I have a trouble about prism layer (boundary layer). I generated the prism layer around the hull, but the software cannot generate prism layer around aft and fore picks (at those locations curvature change too much) You can see this from the pictures at the attachments. Does anybody know how I can solve this problem? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Mar 2009
Posts: 248
Rep Power: 17 ![]() |
Change the curvatures for the mesh?
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
Member
Yogesh Nalam
Join Date: Sep 2012
Location: München, Germany
Posts: 54
Rep Power: 12 ![]() |
Hi,
You can change your boundary march angle in expert properties of prism layer mesh and try again. PFA the image also. Regards, Yogesh |
|
![]() |
![]() |
![]() |
Tags |
boundary layer, mesh generation problem, prism layer |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Questions about Polyhedral and Prism layer meshing | niablis | STAR-CCM+ | 3 | September 23, 2016 00:32 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
Prism layer mesher | Clémence | STAR-CCM+ | 3 | May 20, 2014 10:56 |
Trimmer & prism layer | peresah | STAR-CCM+ | 6 | October 6, 2009 14:39 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |