 |
 |
 |
|
|
|
[Sponsors] | ||||
March 27, 2020, 09:55
|
star CCM+ istallation
|
#1 |
|
Member
Sai Krishna
Join Date: May 2018
Posts: 37
Rep Power: 7  |
when i am trying to open a new project after installation, i couldn't find no option for it. if installation was proper i could have started a new simulation.
i followed the same procedure written in 'read me' but couldn't figure out where i am going wrong. can anyone suggest whats wrong with the installation.....?? thanks in advance |
|
|
|
|
|
March 30, 2020, 03:25
|
|
#2 |
|
Senior Member
Ping
Join Date: Mar 2009
Posts: 556
Rep Power: 20 |
i saw this some years ago and have a vague feeling it is to do with your user appdata folder - look for cd-adapco and delete it after uninstalling all star versions
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 22:15 |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
