Multi-part solid heat transfert

Deresix · April 8, 2020, 05:01

Hi everybody, I'm trying to simulate a water cooled battery pack of an hybrid car. To set up the simulation I followed the "Multi-Part Solid: Graphics Card Cooling" tutorial in the software help.

I defined the interfaces between different materials as part-based contact interfaces.

The resulting mesh is conformal in the majority of the interface surfaces.

While setting the the heat sources I gathered all the cells in one subgroup and defined it as a total heat source. This way, while simulating, the cells does not generate power. To ensure the rest of the model was set up correctly i tried to set the cells as a temperature sources and it works perfectly.

Anyway I'm interested to know the convergence temperature of the cells and not ti set it up as a fixed value. Anyone can explain me what I did wrong?

Deresix · April 9, 2020, 15:24

solved, thanks for your assistance!

April 8, 2020, 05:01	Multi-part solid heat transfert	#1
Deresix New Member Join Date: Jun 2019 Posts: 4 Rep Power: 6	Hi everybody, I'm trying to simulate a water cooled battery pack of an hybrid car. To set up the simulation I followed the "Multi-Part Solid: Graphics Card Cooling" tutorial in the software help. I defined the interfaces between different materials as part-based contact interfaces. The resulting mesh is conformal in the majority of the interface surfaces. While setting the the heat sources I gathered all the cells in one subgroup and defined it as a total heat source. This way, while simulating, the cells does not generate power. To ensure the rest of the model was set up correctly i tried to set the cells as a temperature sources and it works perfectly. Anyway I'm interested to know the convergence temperature of the cells and not ti set it up as a fixed value. Anyone can explain me what I did wrong?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error Messages: Self intersecting faces, Solid Part is not closed, Floating point.	bigtoasty	STAR-CCM+	1	March 4, 2016 05:05
Heat Flux at Internal walls or Fluid Solid Interface	Mahi	CFX	3	October 1, 2012 02:18
Enforce bounds error with heat loss boundary condition at solid walls	Chander	CFX	2	May 1, 2012 20:11
No Heat Transfer between two solid domains	Mike ZH	CFX	7	July 26, 2008 16:50
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

April 9, 2020, 15:24		#2
Deresix New Member Join Date: Jun 2019 Posts: 4 Rep Power: 6	solved, thanks for your assistance!