Easy way to split pressure plots

tambeshakunt · May 21, 2020, 14:59

I currently have a symmetric aerofoil 2D simulation for which I wish to obtain separate pressure distributions on the upper and lower surface.

Considering that I have already run the simulations, what would be the best way to go about this? Is it through a threshold derived part ? How do I go about doing that once I've set the threshold to a position (in y axis) ?

Thank you in advance.

ping · May 26, 2020, 02:59

yes use a threshold with the wing surface as the input part so you have just one half of the wing then create cut section plane through this threshold part to get a line and plot that part. same for the other half

May 21, 2020, 14:59	Easy way to split pressure plots	#1
tambeshakunt New Member Join Date: Feb 2020 Posts: 5 Rep Power: 6	I currently have a symmetric aerofoil 2D simulation for which I wish to obtain separate pressure distributions on the upper and lower surface. Considering that I have already run the simulations, what would be the best way to go about this? Is it through a threshold derived part ? How do I go about doing that once I've set the threshold to a position (in y axis) ? Thank you in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How is total pressure calculated?	looee	CFX	15	October 30, 2019 08:14
question regarding LES of pipe flow - pimpleFoam	Dan1788	OpenFOAM Running, Solving & CFD	37	December 26, 2017 14:42
outlet pressure Boundary settings -velocity streamline under ambient temp.conditions	Vishnu_bharathi	CFX	12	November 21, 2017 06:56
Outlet pressure	aja1345	FLUENT	5	August 18, 2015 11:02
Pulsatile pressure inlet with pressure outlet	a.lynchy	FLUENT	3	March 23, 2012 13:45

May 26, 2020, 02:59		#2
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	yes use a threshold with the wing surface as the input part so you have just one half of the wing then create cut section plane through this threshold part to get a line and plot that part. same for the other half