 |
 |
 |
|
|
|
[Sponsors] | ||||
Defining Relative Humidity while Solving a Simulation with Droplet Evaporation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2020, 05:53
|
Defining Relative Humidity while Solving a Simulation with Droplet Evaporation
|
#1 |
|
Senior Member
mohammad
Join Date: Dec 2010
Location: UK
Posts: 245
Rep Power: 16  |
Dear all,
This is my first time working with the evaporation model in STARCCM+. I am going to simulate evaporation of water-glycerin droplets. I have used Lagrangian multi-phase with the following settings as shown in the attached picture. However, I am wondering where should I insert the relative humidity (RH)? As I know, two factors are very important, Temperature and RH. The temperature tab exists under the "Reference Values". However, there is no sign of RH.  Best, |
|
|
|
|
|
| Tags |
| droplet, evaporation, lagrangian, relative humidity |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem with Min/max rho | tH3f0rC3 | OpenFOAM | 8 | July 31, 2019 09:48 |
| chtMultiRegionSimpleFoam turbulent case | Aditya Patil | OpenFOAM Running, Solving & CFD | 6 | April 24, 2017 22:13 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| Error while running rhoPisoFoam.. | nileshjrane | OpenFOAM Running, Solving & CFD | 8 | August 26, 2010 12:50 |
Linear Mode
