2D Mesh generation warning
1 Attachment(s)
Hi,
I am meshing a pipe which I have constructed in 2D. The pipe length is 20m. I extended the pipe length so it was 100m but now I get the following error message. Attachment 80635 I increased the base size from 0.01m to 0.02m and the automated meshing sequence completed. However, I wanted to keep the same mesh as before so I know the change in output is due to the length change and not a combination of the mesh and the length change. Does anyone know what is causing this error, or the appropriate steps required to remedy the issue? Thanks! |
All times are GMT -4. The time now is 03:47. |