CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   STAR-CCM+ (https://www.cfd-online.com/Forums/star-ccm/)
-   -   Using Report values as boundary values (https://www.cfd-online.com/Forums/star-ccm/234976-using-report-values-boundary-values.html)

koecher March 26, 2021 08:59

Using Report values as boundary values
 
Hi everyone,

i have to set up a simulation with pressure outlets. The mass flow through these outlets is varying and unknown quantitatively. During the calculation, a report records the mass flow. The scalar value of the mass flow should serve as a value for a mass flow inlet at another position (but same fluid region) simultaneously during the calculation. Do any of you see an easier way to use the Mass flow report for a boundary condition other than via a user-coded boundary?

Thanks a lot in advance!

cwl March 29, 2021 01:30

Quote:

Do any of you see an easier way to use the Mass flow report for a boundary condition other than via a user-coded boundary
Just use that Report as a boundary condition?


All times are GMT -4. The time now is 15:34.