|
[Sponsors] |
Changing the "Contour Style" does not changing the view |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 4, 2021, 14:23 |
Changing the "Contour Style" does not changing the view
|
#1 |
New Member
Yağız Ataberk ERİŞTİ
Join Date: Feb 2020
Posts: 7
Rep Power: 6 |
Hi everyone,
I did an analysis, it converged properly and I got my results. But I also want to use the analysis's photo in my report. It doesn't look nice since there is no difference changing the contour style from automatic to smooth filled or just "filled" etc.. When I changed it to Smooth Filled+Lines, it shows the lines but its still not "smoothing" the view. Because I am doing a research, my mesh is very fine and enough I suppose. Any ideas? Cheers.
__________________
------------------------------------------------- Yağız Ataberk ERİŞTİ TOBB ETU - Mechanical Engineering |
|
April 4, 2021, 14:37 |
|
#2 |
New Member
Yağız Ataberk ERİŞTİ
Join Date: Feb 2020
Posts: 7
Rep Power: 6 |
I figured it out,
I clicked the colour bar and changed levels from 32 to 320.
__________________
------------------------------------------------- Yağız Ataberk ERİŞTİ TOBB ETU - Mechanical Engineering |
|
April 4, 2021, 20:02 |
|
#3 | |
Member
Peresvet
Join Date: Mar 2021
Location: USSR
Posts: 48
Rep Power: 5 |
Quote:
However, this is only for the quality of the fill. Then a fine mesh and a multistep solver method are needed for a high-quality water surface. This is necessary to keep the GFL less than 0.15 and to make the solution faster. If this is not done, then you will have to take a long time and it is not a fact that the edges of the cells will not stand out in contrast. |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
loading issue libraries:libsimpleFunctionObjects.so libsimpleSwakFunctionObjects.so | immortality | OpenFOAM Pre-Processing | 15 | April 7, 2024 12:35 |
[PyFoam] Problems with the new PyFoam release | zfaraday | OpenFOAM Community Contributions | 13 | December 9, 2014 18:58 |
[PyFoam] having problems with pyfoam Installation | vitorspadetoventurin | OpenFOAM Community Contributions | 3 | December 2, 2014 07:18 |