 |
 |
 |
|
|
|
[Sponsors] | ||||
How can I find force coefficients on a portion of a surface in STAR-CCM+? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 2, 2021, 08:32
|
How can I find force coefficients on a portion of a surface in STAR-CCM+?
|
#1 |
|
New Member
Mohammad Sheikholeslami
Join Date: Apr 2021
Posts: 4
Rep Power: 5  |
In the report window of STAR-CCM+, the input should be a part or region boundary. How could a portion of a part or region boundary be selected as input?
|
|
|
|
|
|
June 5, 2021, 17:20
|
|
#2 |
|
New Member
Vlad
Join Date: Oct 2020
Posts: 13
Rep Power: 5 |
hmm... i think it could be done by isolating naming that surface in repair mode or in 3d cad, before doing the simulation
|
|
|
|
|
|
|
June 7, 2021, 09:08
|
|
#3 |
|
New Member
Mohammad Sheikholeslami
Join Date: Apr 2021
Posts: 4
Rep Power: 5 |
Thank you. Unfortunately, my simulations are finished, and there is no way to reinitiate or continue them.
|
|
|
|
|
|
|
June 12, 2021, 17:33
|
|
#4 |
|
Senior Member
Chaotic Water
Join Date: Jul 2012
Location: Elgrin Fau
Posts: 435
Rep Power: 17 |
Derived Parts -> Threshold might help.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| calculating Added mass and damping force coefficients matrix | nima99 | STAR-CCM+ | 0 | December 3, 2019 03:56 |
| Processor boundary error surface tension force | jameswilson620 | Main CFD Forum | 4 | October 30, 2017 17:31 |
| Surface Roughness Application in Star CCM+? | Brock17 | STAR-CCM+ | 1 | May 18, 2017 19:47 |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
1Likes
Linear Mode
