Why imprint make my model's surface not show？

Roxine · April 12, 2022, 21:39

I have a model made of some walls and water fluid, I use the imprint function in boolean for all the walls to get their contacts a,but there has been produced to a surface in parts and region for both of walls and fluid,the surface just created is their interface.And some sufaces in my original model can not show,I need to creat a report for some surfaces to get their pressure.So,what should i do? Thank u!

LuckyTran · April 12, 2022, 22:52

Go to derived parts, create, section, arbitrary...

April 12, 2022, 21:39	Why imprint make my model's surface not show？	#1
Roxine New Member Join Date: Apr 2022 Posts: 10 Rep Power: 4	I have a model made of some walls and water fluid, I use the imprint function in boolean for all the walls to get their contacts a,but there has been produced to a surface in parts and region for both of walls and fluid,the surface just created is their interface.And some sufaces in my original model can not show,I need to creat a report for some surfaces to get their pressure.So,what should i do? Thank u!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Defects in surface imprint	cibi	FLUENT	1	May 19, 2023 16:24
Error in gmshToFoam on ESI v2106	siefer92	OpenFOAM Programming & Development	4	July 17, 2021 05:11
how to calculate water average velocity in free surface models	hmasenger	CFX	22	October 30, 2019 19:28
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[ICEM] make tip gap surface, ICEM	Jonathan	ANSYS Meshing & Geometry	2	July 3, 2014 11:06

April 12, 2022, 22:52		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,668 Rep Power: 65	Go to derived parts, create, section, arbitrary...