Convergence Control
I am running steady state simulations for a radial compressor. As a convergence criteria I want to set the change in massflow at the outlet.
So if the change between two iterations is smaller than 0,0004% then the simulation should stop. How do I implement this stopping criteria? |
Hello!
Have you tried with the manual of the software? You need to right-click on "Stopping Criteria", then "New Monitor Criteria" and you select your monitor and the value that you want. Let me know if you succeed or not! |
Quote:
|
thatīs weird, when Star doesnīt let you select it?
Before initializing the solution? Does any message appear? |
Quote:
|
All times are GMT -4. The time now is 15:04. |