[jerayes]

I was just working on a design manager project that would look at different angles of attack for an airfoil. gathering CL and CD.
I set the stopping criteria to 1,000, even though I knew they would converge considerably long before that happened in some AoA cases.
When looking at the live output file that shows the residuals and responses, I can see that the live simulation is converged well enough for me to stop it.
Is there anyway I can abort a single design so it will move on to the next design, before the 1,000 iterations are up?

[Aeronautics El. K.]

Originally Posted by jerayes

I was just working on a design manager project that would look at different angles of attack for an airfoil. gathering CL and CD.
I set the stopping criteria to 1,000, even though I knew they would converge considerably long before that happened in some AoA cases.
When looking at the live output file that shows the residuals and responses, I can see that the live simulation is converged well enough for me to stop it.
Is there anyway I can abort a single design so it will move on to the next design, before the 1,000 iterations are up?

You can setup stopping criteria based on the monitors of lift and drag for example.

[jerayes]

I have since figured this out.
Thank You the response nonetheless

[Aeronautics El. K.]

Originally Posted by jerayes

I have since figured this out.
Thank You the response nonetheless

No problem
Admittedly it was an old post.