 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2023, 05:58
|
Advanced Layer Mesh
|
#1 |
|
New Member
Mohammad Ghiyasi
Join Date: Sep 2023
Posts: 1
Rep Power: 0  |
Hello
I use Advancing Layer Mesher and Anisotropic Surface Size on the airfoil edge to mesh the wings, but I encounter cells with high skewness that you see in the image. What is the solution to improve the quality of these cells? Doesn't removing them lead to a decrease in simulation accuracy? Thanks Advanced Layer Mesh.jpg |
|
|
|
|
 |
| Tags |
| advancing layer mesher, anistropic surface size, wing mesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No generation of layer onto zerothickness surface | crubio.abujas | OpenFOAM Meshing & Mesh Conversion | 3 | October 25, 2022 03:20 |
| [snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |
| [snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 05:56 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
