CFD Online Logo CFD Online URL
Home > Forums > STAR-CCM+

Intake manifold analysis

Register Blogs Members List Search Today's Posts Mark Forums Read

Like Tree1Likes
  • 1 Post By Vinicius

LinkBack Thread Tools Display Modes
Old   July 4, 2010, 01:41
Default Intake manifold analysis
New Member
Join Date: Jun 2010
Posts: 1
Rep Power: 0
alonzoo is on a distinguished road
Hi,everyone,I have encountered a problem while running an analysis for an intake manifold in star ccm.the error message I received was as follows:
Sever error:a floating point has occurred:floating point exception.
And in the residuals window, all the residuals show solution divergence during the first iterations.
Below is my model information:
Geometry dimension:unit mm
Inletiameter:27outlet:ares:380,length:70 section of pipe: ares:820 ,length:105;
mesh models:
surfaces remesherpolyhedral mesherprism layer mesher
reference values:
base size:5 prism layer thickness:2.5relative minimum size(surface size) :1 relative target size(surface size) :2others:default
physical models:
3DstationarysteadyIdeal gassegregated flowstandard k-Epsilon tuberlencehigh y plus wall treatment, click on incompressible in the ideal gas property window.
Reference values:deault
Initial conditions:
Pressure:750pa(half of the pressure difference between inlet and outlet) turbulence length scale:2 mmturbulent intensity:0.04others:default
Boundary conditions:
Inlet:stagnation . total pressure:1500pa.Outletressure out pressure:0pa.
other parameters keep as initial conditions.
alonzoo is offline   Reply With Quote

Old   July 4, 2010, 14:32
Vinicius Girardi
Join Date: Mar 2009
Location: Sao Paulo, Brazil
Posts: 80
Rep Power: 10
Vinicius is on a distinguished road
Try to run some iterations using a velocity or mass flow rate at the inlet. It's better if you know one of these values. Then just go back to your pressure-pressure condition.
y_c_w likes this.

Last edited by Vinicius; July 6, 2010 at 07:01.
Vinicius is offline   Reply With Quote

Old   July 6, 2010, 04:00
Senior Member
Join Date: Mar 2009
Posts: 203
Rep Power: 11
Maddin is on a distinguished road
Ramp the pressure...
Maddin is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
intake manifold simulation uday Main CFD Forum 6 December 21, 2009 02:39
need help with manifold analysis in fluent anil1886 FLUENT 0 August 29, 2009 10:29
Intake manifold analysis mehndan Siemens 3 August 22, 2008 04:24
Intake manifold analysis mehndan Main CFD Forum 6 July 3, 2008 05:28
Modeling of a airflow in a intake manifold Jack FLUENT 1 September 21, 2003 22:22

All times are GMT -4. The time now is 04:59.