 |
 |
 |
|
|
|
[Sponsors] | ||||
July 28, 2010, 05:17
|
Multiregion mesh
|
#1 |
|
New Member
Join Date: Jul 2010
Posts: 29
Rep Power: 15  |
Hello,
What I should do to combine two different meshes (tetra, trimmer) on two regions (interfaces between regions were created)? Look at this catastrophe thanks for any help |
|
|
|
|
|
August 3, 2010, 05:37
|
|
#2 |
|
New Member
Join Date: Jul 2010
Posts: 11
Rep Power: 15 |
I'd mesh both regions poly. If you use the same mesh continuum for both regions and create the interface before meshing you get conformal mesh.
Also works with tets, but tets have only disadvantages compared to poly. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
| mesh missing after export in gambit | morteza08 | ANSYS Meshing & Geometry | 1 | July 26, 2010 01:10 |
| 2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
Linear Mode
