Cannot Open .sim (Floating Point Exception)

trex930 · July 30, 2010, 04:18

Hi all!

Ran into a major problem today. I had finished running my simulation in StarCCM+ and everything was dandy so I saved it and exited the progam. After a couple of hours, I tried to re-open my .sim file and heres the error i get.

"A floating point exception has occurred: foating point exception [invalid operation]. The specific cause cannot be identified. Please refer to the toubleshooting section of the User's Guide."

the odd thing is, I had always thought floating point exception occurs if something was getting divided by a zero. But the simulation is finished. so that shouldnt happen. Anyone have any idea on how to fix this?

Thanks in Advance,
T

svenne · July 30, 2010, 06:51

Hi trex,

such an error cannot only occur while obtaining a solution, but also if you use an fieldFunction and divide by zero within this function.
Do you use any fieldFunctions which could create such a behavior?

Does the same error occur if you open the backup (.sim~) file?

July 30, 2010, 04:18	Cannot Open .sim (Floating Point Exception)	#1
trex930 Member Join Date: Jun 2010 Posts: 33 Rep Power: 15	Hi all! Ran into a major problem today. I had finished running my simulation in StarCCM+ and everything was dandy so I saved it and exited the progam. After a couple of hours, I tried to re-open my .sim file and heres the error i get. "A floating point exception has occurred: foating point exception [invalid operation]. The specific cause cannot be identified. Please refer to the toubleshooting section of the User's Guide." the odd thing is, I had always thought floating point exception occurs if something was getting divided by a zero. But the simulation is finished. so that shouldnt happen. Anyone have any idea on how to fix this? Thanks in Advance, T

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Floating point exception error	Alan	OpenFOAM Running, Solving & CFD	11	July 1, 2021 21:51
MPI Error - simpleFoam - Floating Point Exception	scott	OpenFOAM Running, Solving & CFD	3	April 13, 2012 16:34
Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory'	mfiandor	OpenFOAM Installation	2	January 25, 2010 09:50
Floating point exception error with small DeltaT	rassilon	OpenFOAM Running, Solving & CFD	19	September 2, 2009 07:39
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 02:27

July 30, 2010, 06:51		#2
svenne New Member sven Join Date: Jul 2010 Location: Germany Posts: 7 Rep Power: 15	Hi trex, such an error cannot only occur while obtaining a solution, but also if you use an fieldFunction and divide by zero within this function. Do you use any fieldFunctions which could create such a behavior? Does the same error occur if you open the backup (.sim~) file?