|
[Sponsors] |
August 6, 2010, 03:38 |
About create interface!
|
#1 |
New Member
Leon
Join Date: Aug 2010
Posts: 10
Rep Power: 15 |
I want to create interface between two boundaries, first,I create the model in the UG NX 6, import a curved suface with the thickness of 2mm, then I create one big cuboid use the cuboid split the curved surface,and retain the curved surface. then import the geometry into star_ccm+, there are two bodies,split the cubiod boundry by path, select the 6 faces of the cubiod, then the left surface will be the interface surfaces, select the left surfaces of the cubiod and all the curved surface's faces create "in-place interface", do mesh remesher, and,at last... error
|
|
August 6, 2010, 11:05 |
|
#2 |
New Member
Join Date: Aug 2010
Posts: 3
Rep Power: 15 |
Make sure all of the geometery is created in UG broken out the way you want it before importing via IGES or equivalent into Star CCM+. I use to have this problem as well, but when I created all of the different volumes in Catia at once and imported the entire model into Star CCM+ it worked fine for me. Hope this helps.
|
|
August 6, 2010, 20:47 |
|
#3 |
New Member
Leon
Join Date: Aug 2010
Posts: 10
Rep Power: 15 |
Thanks,I will try!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |