|
[Sponsors] |
May 11, 2011, 09:54 |
air duct
|
#1 |
New Member
Join Date: Apr 2011
Posts: 3
Rep Power: 14 |
Hi,
I simulate the flow inside the air duct. The air speed at inlet boundary is produced by fan. The air speed is 27.7m/s. The reference pressure is set to 101325Pa. When I read the results I obtain about 70Pa of pressure at inlet. I have the results from other simulation where for 13m/s at inlet they have obout 480Pa of pressure. Do You think that these difference is due to other reference pressure (fan pressure taken into account)..? Best regards Jarek |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling free falling water into a air filled duct? | sandmike_83 | CFX | 4 | August 24, 2010 03:27 |
Duct air flow modeling | Dan SW FL | Main CFD Forum | 2 | July 6, 2010 04:57 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
roghness of a steel air duct | giogio | FLUENT | 0 | January 18, 2008 11:56 |
rectangular elbow air duct problem | tony | FLUENT | 2 | August 20, 2006 19:07 |