evaporation using VOF in STAR CCM+ -- CFD Online Discussion Forums

August 10, 2011, 07:04	evaporation using VOF in STAR CCM+	#1
aaron_lan New Member slan Join Date: Nov 2010 Location: Eindhoven Posts: 19 Rep Power: 16	Hey guys, Does anyone have the experience of modeling evaporation using VOF method? Currently, there is no default evaporation available, so I need to add an evaporation model by myself. Does anyone have any idea for this? Thank you very much for any suggestions. Best regards, Aaron

August 27, 2011, 20:34		#2
naimishharpal Member Naimish Harpal (MS Aerospace Engr) Join Date: Jul 2009 Location: Long Beach, CA Posts: 50 Rep Power: 17	Is Boiling model different than Evaporation model?

July 27, 2018, 10:26

akchetty

New Member

A K Chetty

Join Date: Apr 2017

Location: West Lafayette

Posts: 6

Rep Power: 10

Check out the manual instructions in this pdf doc

Attached Files

Evap_VOF.pdf (108.0 KB, 90 views)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
Question:Considerations about the evaporation in VOF	dokeun	FLUENT	10	February 24, 2011 20:47
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
error in star ccm	maurizio	Siemens	3	October 16, 2007 05:17
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 13:29.