CFD Online Discussion Forums

CFD Online Discussion Forums (
-   STAR-CD (
-   -   negvol error in starcd (

amithmg May 12, 2012 05:19

negvol error in starcd
hi all,
i am getting error of neg volume in create results. when i gave th run iterations stopped at 12 saying negative densities found. can anyone tell me the solution to fix the error.

Blanco July 18, 2012 07:07

is this a moving mesh or a static mesh?
The run stops because probably you have a very bad mesh...

krishnag2002 July 18, 2012 21:08

U can repair in static mesh
you can do these steps after finishing create results
1. read result
2. type check negvol 10 ice <here 10 is just randam cset, u can use different also>
3. cset news cset 10
4. cplo
5. check these cells, where it is, if it is in static region correct them by using filling linear or some other else.

I think u know most of these, but for info i am written here.

Please inform the present status

All times are GMT -4. The time now is 14:42.