 |
 |
 |
|
|
|
[Sponsors] | ||||
Fluid Regions donot communicate via "Attach" Boundaries |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 28, 2009, 13:26
|
Fluid Regions donot communicate via "Attach" Boundaries
|
#1 |
|
New Member
Sameera Wijeyakulasuriya
Join Date: Aug 2009
Posts: 12
Rep Power: 16  |
I'm simulating a 2D sliding mesh case in starcd 3.26.131. The fluid regions do not communicate across the attach boundaries I have specified. I can see that the boundaries are properly matched upon executing the command "eoslide...". I'm running parallel and have made sure that the cells across the sliding interface lies in a single processor. Further I'm using loadsteps to change BCns and ufiles to initialize the fluid domains.
Any ideas why the fluid regions are not communicating with each other? |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| isolated fluid regions were found | alfin | CFX | 14 | October 8, 2015 01:36 |
| How to apply negtive pressure to outlet | bioman66 | CFX | 5 | June 3, 2006 01:40 |
| My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
| separating fluid regions | David C | FLUENT | 1 | March 7, 2001 10:52 |
Linear Mode
