CFD Online Discussion Forums

CFD Online Discussion Forums (
-   STAR-CD (
-   -   Template Generation Problem (

en51nm September 17, 2009 08:14

Template Generation Problem

I am currently attempting to create a template for a trim mesh in STAR CD using the AutoMesh-Classic panel.

The template has a number of refinement boxes created in the "Volume Based Refinement" settings.

Once the template has been created I use the Mesh Tools to check the cells and all of the cells in the refinement boxes are "disconnected".

I'm assuming that the template generator has not created couples, however I don't know how to turn these couples on?

I can't imagine I would have to manually couple the refinement boxes...?

Any ideas?


All times are GMT -4. The time now is 15:03.